Automotive Design & Production is the one media brand invested in delivering your message in print, online, via email, and in-person to the right automotive industry professionals at the right time.
Issue link: https://adp.epubxp.com/i/578863
October 2015 — 5 While grille mesh is ordinarily a design feature, the mesh for the Z06 makes a diference to the performance of the vehicle, as it is designed to deliver the maximum amount of airfow into the supercharger's intercooler heat exchanger—in fact, the mesh pattern used does a better job of managing airfow than would be the case were the entire grille simply removed. (To get rid of that air, there is a large hood vent: were that air to be channeled under the car, there's the danger that it would create lift; an objective of the program development was to create as much downforce as is practical; the car is said to have the most downforce of any production car GM has tested.) The structure of the Z06 is aluminum, and it is so stif that it isn't necessary to add structural reinforcements to accommodate a convertible model of the Z06. The non- convertible version has a removal carbon fber roof panel. With the panel installed, the structure is 60% stifer than the previous-generation fxed-roof Corvette. With the panel removed, it is still 20% more structurally rigid. There are two types of seats available (GT for everyday driving; Competition Sport for those so inclined to take p The Z06 has an LT4 V8 under its composite hood, a small-block engine that has massive performance, as in 650 hp and 650 lb-ft of torque. It has an aluminum block and heads. advantage of the car's capabilities [e.g., 0 to 60 mph in 2.95 seconds with the eight-speed automatic; lateral acceleration of 1.2 g; 60 to 0 mph braking in 99.6 ft.]); both seat types feature magnesium frames. (It is probably worth noting that in addition to carbon fber interior trim there is a steel-reinforced grab bar on the edge of the center console for the passenger.) The LT4 engine in the Z06 is based on the Gen 5 small block that's used in the Stingray's LT1 6.2-liter naturally aspirated engine, yet it has been cleverly engineered to produce 650 hp, signifcantly more than the LT1's 455 hp (460 hp with a performance exhaust package). The LT4 engine features Rotocast A356T6 aluminum cylinder heads; the casting process, which uses cen- trifugal force to move the molten metal into the mold, produces heads that are more capable of handling heat than conventional aluminum heads. The intake valves are titanium. The connecting rods are machined, forged power metal steel. There are forged aluminum pistons that have polymer-coated skirts to prevent bore scufng. The exhaust manifolds are stainless steel. There is an aluminum balancer. The supercharger was designed to be more compact than is typically the case. This compact unit—an assembly that combines the supercharger and the intercooler—fts within the valley between the cylinder heads. This means that the LT4 engine in the Z06 is 25 mm taller than the LT1 engine in the conventional Corvette—but it also provides some 37% more horsepower and 40% more torque (remember: performance and mass). The eight-speed transmission, the 8L90, is engineered so that it fts within the same package space as the six-speed transmission used in the Corvette Stingray. The 8L90 makes extensive use of aluminum and magnesium in its construction. Consequently, it is 4-kg lighter than the six-speed. Curb weight for the Corvette Z06: 3,524 lb. t A lightweighting strategy—using materials including carbon fber composites, aluminum, and magnesium—is used for the Corvette Z06, a car that you can do this with—or that you can drive to the store in to pick up a gallon of milk.